show_chart
Profiles anywhere
Draw a profile across the terrain, or along the fall line through a point – perpendicular to the contours.
Profiles and road alignments in minutes
Click on the terrain to draw a profile or a road. Every corner of a road gets its curve, the chainage is counted for you, and the longitudinal profile, the cross sections and the volumes follow.
Three clicks to a road
ads_click
Click on the terrain
Place the corners of the alignment; a double-click finishes it and you give it a name.
roundabout_right
Adjust the curves
Every corner gets a smooth curve. Right-click a corner to change its radius, or the road for more options.
area_chart
Read the profile and volumes
The longitudinal profile and the cross sections open below the 3D view, with cut and fill along the chainage.
From the first sketch to the drawings
straighten
Chainage and grade
Chainage is counted along the alignment; set the vertical alignment with its intersection points and read the grade.
view_week
Cross sections
Sections every 1 to 50 m, at the width you choose, with the terrain, the geology and the design.
calculate
Cut and fill volumes
Volumes between sections by the average end area method: fill, cut and net, in m³.
plumbing
Pipes and levels
Show pipe axes with their invert levels in the profile, next to the ground and the layers.
picture_as_pdf
Drawings and exports
White drawing with title block in PNG, SVG or PDF; DXF for CAD; DXF for Slide2 slope-stability analysis.
landslide
Ready for slope stability
Send a section with its layers to Slide2 as DXF, and bring the Slide2 or RS2 drawing back into the profile.